How To Make 12 Volt Battery Short-Circuit Protection Circuit with over discharge and overload protection circuit.
How To Make 12 Volt Battery Short-Circuit Protection Circuit with over discharge and overload protection circuit. This circuit developed by AMKP40 technology. 🔥⚙️Main Features Of This Circuit... (1) Short-Circuit Protection. (2) Over Discharge Protection [ Less than 7v DC this circuit turns OFF]. (3) Over Load Protection [it may not work properly]. This circuit working very perfectly with any 12V Battery. IMPORTANT:– THIS CONSUME POWER WHILE CIRCUIT IS ON STATE. This circuit consume just little amount of power. ☝🏻☝🏻☝🏻☝🏻 Instead Of This Coil you can use ceramic resistor depending how much ampere you want to drive with this circuit, considering the Relay's Max Ampere rating. Know about this single pole double stroke 12v Relay. NO= Normally Open Pin, which not connected with any other pins until Relay not turns ON. NC= Normally Close Pin, which is connected with common pin of this circuit, until Relay turns ON. And Coil Pin-1 and Coil Pin-2 connected both each and oth